The transmitters included with the system have been pre - programmed at the
factory, with each button pre - assigned to control a specific function of the
system. Although the system in the vehicle has either a 3, 4, or 5 channel
RECEIVER, depending on the model, the transmitters included with the system
are 7 channel transmitters. This allows you to program each transmitter to
more than one vehicle in two car families, and also allows you to change which
button or buttons control certain functions of the system. (
Example:
Transmitter channel 5, shown below, can be programmed to activate Receiver
channel 2.) Refer to the chart below for access to each of the transmitter
channels, and for the standard factory button assignments.
Model : APS99BT3
1 1 Remote Arm & Disarm
*Remote Emergency Panic
*Remote Door Lock & Unlock
2 OPT. 1 3 Push And Hold For 3 Seconds For Opt1
Release, Push 2 Times For Aux. Out.
3 OPT. 2 4 ** Pulsed Output for Accessories
4 5 ** Switched Output for Accessories
5--
6--
7--
* Remote Emergency Panic is available only on certain models.
* Door Lock/Unlock may require additional components in certain vehicles.
** Some of the more common accessories for these additional channels are;
AS 9075 Remote Car Starter
AS 9256 Remote Trunk Release Relay
AS 9154 Remote Garage Door Interface
AS 9153 Remote Window Roll Up
TRANSMITTER SYSTEM RECEIVER
CHANNEL BUTTONS CHANNEL FUNCTION
&
&
&
&
&
To Next Page
Need help?
General