Audiovox Prestige Platinum APS-410a User Manual

128-6468
1 of 10
Model APS-410a
Owner’s Manual
4 Button Remote Security System
with Dual Stage Shock Sensor
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situations.
In addition, the chart on the last page of this manual has a section for the particular features and
options installed in your vehicle as well as the override method selected. Valet Switch manual
override is pre-selected from the factory, however, the system can be configured for "Custom
Code" operation. Confirm the override mode selected on the last page of this manual and
familiarize yourself with the selection on it's operation.
FEATURES :
w 2 Four Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w Four Channel Receiver
w Code Hopping Technology
w Selectable Manual Override Mode
w Remote Panic in all modes
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED (Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable (Optional relay required)
w Additional Engine Immobilizer Output (optional relay required)
w True Last Door Arming (hardwire only)
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds /1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter
w 6 Tone Multi-Tone Siren
w RF Inhibit with ignition on
w Parking Light Flasher
w Plug In Dual Stage Shock Sensor
OPTIONS :
w Starter Disable
w Remote Trunk Release (must have electronic trunk release)
w Remote Keyless Entry (must have power door locks)
w Multiple Vehicle Capable
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Two Step Unlock Configurable

Audiovox Prestige Platinum APS-410a Specifications

General

Type	Car Alarm
Remote Start	Yes
Two-Way Communication	No
Shock Sensor	Yes
Keyless Entry	Yes
Panic Mode	Yes
Starter Kill	Yes
Number of Buttons on Remotes	4
Number of Remotes Included	2

Summary

System Operation and Control

Code Hopping Transmitter Technology

Explains the advanced radio frequency transmission technology used by the transmitters for security.

Active System Arming

Details the procedure for actively arming the security system using the transmitter.

Silent System Arming

Describes the process for arming the system without audible feedback.

Passive System Arming

Explains the automatic arming sequence and its behavior when entry points are opened.

System Disarming

Provides instructions for disarming the security system using the transmitter.

Silent System Disarming

Describes the process for disarming the system without audible feedback.

Protection While Armed

Outlines the system's behavior and deterrents when the security system is active.

Intrusion Warning Signals

Details how the system indicates past intrusion attempts using LED and siren feedback.

Remote Panic Operation

Explains how to use the transmitter's panic function for emergencies.

Additional Remote Functions

Covers activation of optional accessories via transmitter channels 3 and 4.

Ignition Controlled Lock Unlock

Describes automatic door locking/unlocking based on ignition status.

System Override and Customization

Valet Switch Operation

Explains how to use the valet switch to temporarily bypass alarm functions.

Valet Switch Manual Override

Details the procedure to disarm the system using the valet switch without a transmitter.

Custom Override Code Programming

Guides on programming a personal override code for enhanced security.

Custom Code Override Operation

Explains how to use the custom programmed override code.

Eliminating Arm/Disarm Chirps

Instructions on how to disable or enable audible chirps for arming/disarming.

System Functions at a Glance

Dash LED Indicators

Summary of LED flash patterns and their meanings.

Siren Chirp Indicators

Summary of siren chirp patterns and their meanings.

Parking Lamp Indicators

Summary of parking light flash patterns and their meanings.