L
If the secret number is not included in the
linked number, you need not enter the three-
digit security code in the above operation.
2. To complete the call, continue operations as
shown in steps 7 and 8.
Press ~, then key ~.
Linking Mark" = " will be added at the end of the
number and win appe~--
SCRATCH-PADDIALING
This feature peffilits you to enter a number to be
redialed (or store a number in memory) while
engaged in a conversation.
SCRA TCH-P AD DIALING
WITH OUT KE YIN GTO NES
!c
3. Recall your ID number stored in secret memory.
3-1 Enter the three-digit security code.
p "
k ~~~
ress eys ~, ~, ~"
L
Note: When you recall the ID number stored without
secret memory, omit step 3-1 and proceed to
next step 3-2.
3-2 RecalIyour'ID number.
4.
This feature permits you to activate scratch-pad
memory without annoying key tones over the circuit.
1. Press en key ~, then enter a phone
numbe will be displayed for 5 seconds.
The microphone circuit win remain active, but the
tones will not be heard.
2. If necessary , press ~10 , then enter the memory
address.
3. To exit the Scratch-pad Mode, press ~, then
key ~ again or turn the unit off.
~
DATA TRANSMISSION
AUX 1/0 JACK on the phone cradle can be used for a
FAX machine, Modem or other Data Transmitting
equipment Specifications of AUX 1/0 JACK are as
follows.
5. Recall or dial the phone number to be called.
Press, then enter the memory address (01
through 90 and 96through 99) to recall the phone
number to be called.
6. Press
the c
reado
7. After you received an answer from the long distance
service office, press again. The DTMF
signal will be placed an e DTMF tone of your ID
r can be monitored through the loudspeaker.
win appear on the readout
8. your number is accepted, the long distance
service office will an sweLagain, sopres$
Then the long distance call win be placed and the
DTMF to e can be monitored through the loudspeaker.
win appear on the readout
Note: The number linked in steps 1 through 5 can also
be stored in secret memory as stated in the
"Secret Memory".
1. When a set of linked numbers which includes
a secret number has been stored in memory
address enter the three-digit security code,
, memory addr en
ace the call. will
appear on e readout, and the rst mked
number will be called as shown in step 6
above.
JACK: RJll
Iiripedance:600 ohriis;U-nDalance ---~
Level: Input nominal-17 dBV
: Output nominal-32dBV
Manual Mode
To set Data Transmission Mode
After a call is in progress {answered or sent), press
~ , then ~, ~wi1l appear on the readout
Then the transmission and receiving audio will be
switched to the AUX 1/0 JACK
To Exit Data Transmission Mode
Press ~ , then ~ , or terminate a call.
The indication f;;};ata' on the readout will go out
~6
L
To Next Page
Loading...
