Note (1) : The f'ROAMi indicator lights as follows.
ughts continuously;
When the unit is in the preferred system
in another city.
Flashes;
When the unit is in the non-preferred
Note(2): The indicator flashes when the
unit is requesting service but not in the
requested service area.
More distant family Sill's (like cousins) that your
cellular service provider has roamin agreements with
will be displayed as a solid When flashing
is displayed, you are using a Sill system that
IS not mc uded in the NAM assigned ou s.
If your display indicates flashing you will
need to change your NB switch selection or refer to
Multiple City Registration to change phone registra-
tion to enable you to make a call.
If in question as to what Sill (system identification)
you are using, push ;Rce, 1 ~' 00 to display the
current Sill.
MUL TIPLE CITY
REGISTRATION
Am SYSTEM SELECTION
Some cellular users find it beneficial to register their
phone in multiple cities, rather than rely on "roam".
The multiple city registration feature permits you to
reprogram from the handset, the different phone
numbers for the cities in which you are registered.
Each programmed phone number will be designated
as your home system.
This feature pennits you to select the system you need
to use. The system that you are registered with is the
preferred system, and your home system.
Press ~, then enter the new system ID number
(5 digits) followed by the corresponding phone
number (10 digits) .Please include your area code.
You must register your unit with the carrier in order
to get both system ID number and your phone
number.
Press ~ then key [iJ. Your new phone number wiJ
be displayed on the readout (Holding down rm .t(
display your new system ill number.)
Note(l): System ID number and phone number can
not be programmed during aca1l.
Note(2): Calls are placed or received using only the
programmed phone number, in use at the
time of call.
LAST RESCAN SID
INDICATOR
1. Standard Mode
When you turn the unit on, the unit remembers the
last position of the A/B system selected, and will
start to scan the radio frequency channels of that
selection.
If you want to confirnl the current mode, press
~, key [2} then 00. Status indicator shows the
current mode. To return the unit to the standard
mode, press ~ ' key fQJ then [Qj again.
Status indicator shows ~. The unit will scan the
preferred system channels.
If unable to find an acceptable preferred channel,
the unit switches to scan the non-preferred
channels.
2. Preferred System Only Mode
Press lOO ' key tQ] then [[]. Status indicator
shows ~.The unit will scan the preferred
system only and prevents switching over to the non-
.preferred system.
3. Non-preferred System Only Mode
Press ~ , key [Q] then ~ .Status indicator
shows ~ .The unit will scan the non-
preferred system only.
4. Home Only Mode
Press ~, key ~ then fi!. Status indicator shows
~ .You can place or receive calls only within
your home area.
This feature permits you to recall the last system
identification accessed by your phone.
Press '~~t! , key ~ then [g].
The last rescan Sill is displayed on the readout for
5sec.. The display format is as follows:
To Next Page
Loading...
