.
Automatic Mode
1. Before leaving the car. Press ~ , then key ~
(more than 1 second) .The display shows ;~D'f:]; .
The unit will remain power-on even after the
igriition switch is turned off .If necessary, lock the
unit
2. When a call is received, the unit will automatically
make the connection, then the transmit and receive
audio will be switched to the AUX 1/0 JACK
3. This mode is automatically deactivated in the
following cases:
1) When the ignition switch is turned back to "on"
or "accessory" position.
2) When the safety timer is expired. (Refer to "Safety
TlIDer".)
3)When ~, then key ~ are pressed again.
4)When Calls in Absence Indicator feature is
activated.
CALL TIME DISPLA y
To Display the Number of Calls
1
Pr ~ k ~
th ~3-
.ess~, ey ~ en t2J.
The number of calls will be displayed on the readout
for 5 seconds. The display format is as follows.
Received or placed 86 calls
Outgoing Call Ttmer Only
(NAM Option)
Normal call timer operation is to time both the calls
made and the calls received. If the" outgoing call timer
only" function is activated (NAM Option) , the call
timer will only accumulate the number of calls and
amount of time when placing calls. It will not
accumulate the number of calls or amount of time for
calls received.
To Clear the Timer
1. Press [gOO , then enter the three-digit security
code.
2
Pr ~STO' k ~ th [4'1 .ess ~, ey~ enw.
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes ( a short monotone signal will sound every
minute and a double beep tone will be. heard after
approximately 5 minutes.) .
SID MANAGEMENT
(NAM OPTION)
This feature enables you (by NAM option) to take
advantage of the family of Sill groups. This is a group
of cellular systems in cities that your carrier owns or
has special billing arrangements with. Your close
family Sill's Oike brothers and sisters) will be billed at
the same rate as your home billing and will be
indicated as "Home" (i. e. both INO'S\Jt1 and tROAMj
are off) on your display.
This feature automatically records the elapsed time
. " per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the
approximate talk time (NAM Option) in approximately
60 second increments.
To Display the Talk Time of
the Last Call
-L Press ~, key- ~ then ~ c --
The talk time of the last call will be displayed on the
readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each
second. The display format is as follows.
[O1m25j ...1 min. and 25 sec.
To Display the Cumulative Talk Time
1. Press ~,key ~ then ~.
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
em ...18min.
28
29
To Next Page
Loading...
