EasyManua.ls Logo

Audiovox FRS122-2 - User Manual

Audiovox FRS122-2
21 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
128-6675
1 of 24
FAMILY RADIO SERVICE (FRS)
Model
::
::
:
FRS122-2
Released: 3-10-03
OwnerOwner
OwnerOwner
Owner
’s Man’s Man
’s Man’s Man
’s Man
ualual
ualual
ual
© 2003 Audiovox Electronics Corp., Hauppauge, NY 11788
MODE
LOHI

Table of Contents

Questions and Answers

  • D
    daniel94Jul 31, 2025
    Why is my Audiovox Two-Way Radio receiving a weak signal?
    • C
      Christopher ColonJul 31, 2025
      If you are experiencing a weak or no signal on your Audiovox Two-Way Radio, several factors could be the cause. First, check the battery strength and charge or replace them if they are weak. Ensure that the channel and privacy code settings match those of the target transceiver. Also, verify that the volume level is adequately high and that the PTT button is not inadvertently depressed. If interference is present on the current channel, try switching to a different channel. Finally, avoid operating the radio in or near large buildings or vehicles that could obstruct the signal.
  • M
    Mr. Adam RhodesAug 8, 2025
    What to do if my Audiovox FRS122-2 Two-Way Radio is picking up unwanted signals?
    • R
      Rebecca ShafferAug 8, 2025
      If your Audiovox Two-Way Radio is receiving unwanted signals, it might be due to the CTCSS privacy mode not being enabled. Turn on the CTCSS privacy mode and set the code number to match the setting of the target transceiver. Another cause could be interference from electronic devices such as computers or TVs. Try turning these devices off or moving farther away from them.
  • M
    Melissa StevensAug 14, 2025
    How to fix Audiovox FRS122-2 Two-Way Radio when it won't transmit?
    • J
      joseph20Aug 14, 2025
      If your Audiovox Two-Way Radio is not transmitting when you press the PTT button, it could be due to weak batteries. Charge or replace the batteries. Alternatively, the batteries may be installed with incorrect polarity. Ensure you install the batteries following the directions in the manual.
  • S
    Sara SpencerAug 22, 2025
    What to do if Audiovox FRS122-2 beeps but won't turn on?
    • D
      Daniel TaylorAug 23, 2025
      If your Audiovox Two-Way Radio beeps but does not function when turned on, the batteries may be extremely discharged. Try charging or replacing the batteries.

Summary

Safety and Cautionary Information

Handling and Environmental Precautions

Warnings on battery charging, temperature limits, and product care.

Operational Safety Guidelines

Conditions for device use and interference acceptance.

Equipment and Accessories

Powering Your Transceiver

Guidance on using alkaline and rechargeable batteries for operation.

Battery Charging and Care

Procedures for charging rechargeable batteries and warnings for alkaline types.

Installing the Batteries

Transceiver Operational Modes

Understanding Operating Modes

Navigating Transceiver Controls

FRS Communication Procedures

Basic FRS Operation Steps

Channel and CTCSS Selection

Channel Scan Operation

Important Notes and Warnings

Safety Warnings and Precautions

Troubleshooting Guide

Technical Specifications

Audiovox FRS122-2 Specifications

General IconGeneral
Frequency Range462.5625 - 467.7125 MHz
Channels14
Power Output0.5 Watts
Privacy Codes38 CTCSS
RangeUp to 2 miles
Battery Type3 AAA batteries
Water ResistanceNo
Included AccessoriesBelt clip
TypeFRS/GMRS Two-Way Radio

Related product manuals