Audiovox IM-100 - User Manual

..
5. Pre-wire radio. Slide radio into din sleeve until it
locks into place. Note: Use either rear bushing
or perforated strap to secure rear of radio.
RADIO REMOVAL (IF NECESSARY)
1. Unsnap trimring on face of radio.
2. Insert removal tool in slotted holes on sides of
radio until bottomed. Spread tools outward slightly
and pull radio toward you. Remove tools and
slide radio fully out.
DIN MOUNTING (EXAMPLE:VOLKSWAGON)
SEE FIG. 1
1. Verify opening is within following dimensions:
A. Height 52mm- 53mm (23/64" -23/32")
B. Width 182mm -184mm (75/32" -71/4")
2. If opening is less, carefull file to exact size
required (DO NOT OVER FILE).
3. Remove din sleeve from radio and place into
opening.
4. Bend tabs outward to lock sleeve into dash.
rFjG:1l .~ ~ --USE EITHER BUSHING
I rlu. I I 11;r'.../ OR PERFORATED STRAP
@ TO SUPPORT REAR OF RADIO
.1 \LJ
\\
~
4
) ~
BEND TABS
~
~
~@~ I;/
~ ~' (J(~
~~ ~II ~lY A (;AO7
r
OUTWARD
..".J
"
,
~
~
0
DASH PANEL
.;J-
DIN SLEEVE
.
~
-~~
l ~~
~~
~
~
,
~ADIO REMOV ~ """' ~
/ ~(
~
/I
,f
'"""
:.,.( APPLY SLIGHT
TRIMBEZEL (INSTALLED ON RADIO)
1..., j ~
REMOVAL TOOL
TRIMRING
~
QUICKIE BOL T
/'

Audiovox IM-100 Specifications

General

Brand	Audiovox
Model	IM-100
Category	Car Receiver
Tuner Bands	AM/FM
Media Type	Cassette
Outputs	4-channel

Summary

DIN Mounting Procedure

DIN Sleeve Installation

Step-by-step guide for fitting the DIN sleeve into the dash opening and securing the radio.

Radio Removal

Instructions for removing the radio from the dashboard using specialized tools.

Factory Style Installation

Toyota Factory Style Installation

Steps for installing the radio into a Toyota vehicle using the factory bracket assembly.

Radio Removal (Factory Style)

Procedure for removing the radio when installed using the factory style method.