Changing the Rear Zone Source
To access the SOURCE MENU, touch the TFT screen in the top left corner of the screen.
This menu allows you to select a source for the front or rear
zone. Touch FRONT or REAR to choose the zone for which you would like to specify the source.
Controlling the Rear Zone Screen(s)
If you have a rear touch screen installed, you can touch the screen to control most rear zone functions. You can also
use the remote control. The VME 9122 TS remote controls both the front and rear zones. To switch from front to rear
zone, move the F/R switch (32) located on the right side of the remote controller.
NOTE: You cannot change or control the front zone source from the rear zone video screen.
Touch the REAR button on the left side of the screen to view a “Picture in Picture” image of the rear screen.
Turning the Rear Screen Off
Touch the OFF button (on the SOURCE MENU) to suspend operation of the rear screen. Any operation assigned exclu-
sively to the rear source will be suspended until reactivated using either the front or rear zone touch screen or
the remote control.
SETUP MENU
To access system settings, press the SETUP button (31) on the remote control or touch the button on the screen to
enter the “SETUP” menu. The “GENERAL” sub-menu appears highlighted in blue.
72
Subject to technical changes
To Next Page
Loading...
Need help?
General
