auna 388 DAB+ - C) DAB Encoding; D) Cassette;Phono;AUX-in;BT Encoding; E) Track Separation

43
EN
C) DAB encoding
1. Operate tuner mode refer above listening to radio section to receive the
station you would like to encode.
2. Press the REC button (4) twice until the unit will display ashing with
“REC USB” icon. Encoding is now performing.
3. After nish of recoding, press STOP button (3) until the symbol “REC
USB” disappear.
D) Cassette/Phono/AUX-in/BT encoding
1. Plug in the USB pen drive or SD/MMC card for recording (make sure it
had enough empty space).
2. Set the unit to your desired encoding mode by function button (10) such
as “tape” mode or “phono/aux-in” or “BT”…etc and then start to playback
the track would like to encode, then press the
 button (4) twice.
3. The LCD display (2) will ash with “REC USB” or “REC SD” icon. Now the
system is starting the encoding mode.
4. Start playback the track of cassette tape or your external Aux device or
BT device that you prepare to encoding to MP3 format. Now the system
is starting the encoding mode.
5. After nishing of recoding, press “Stop” button (3) until the symbol
“USB” “REC USB” or “REC SD” disappear.
Remark: After setting the encoding mode (step 2):
1. If both USB and SD card are connected to the unit during encoding, the
LCD display (2) will have “Check USB SD” (with “USB” ashing) after
pressing once of the
 button (4).
2. Press  or  button (23/13) to select the desired media (USB or SD) for
recording.
3. Press the
 button (4) again to conrm the recording media.
4. Continue step 4 of the above operation
E) track separation (On remote control only)
You can divide the recording music from tape or DAB…etc in to USB track
by track during encoding. Every time when press the “TS” (track separation)
button (on remote control) once during encoding from tape or Aux in, the
system will generate a new track and continuous the recording. The text
“SAVE” at LCD display will ash one time, it mean the unit is creating a new
track successfully.