45
EN
Remark : As some kind of record the auto-stop area was out of the unit
setting, so it will stop before the last rack nish. In this case, select the auto-
stop switch (24) to "o" position, then it will run to the end of the record but
will not stop automatically (turn o the unit by power button or switch back
the auto-stop switch to “ on “ position to stop the platter rotate). Then put
back the tone arm to the rest position.
LISTENING TO TAPE
Stop/eject key
Press to stop all deck operation.
Press again to open the cassette
door
Fast forward key &
Fast rewind key
Press to start rapid tape winding in
either forward or reverse direction.
Press stop / fast rewind key eject
keys when the cassette spools stop
turning.
Play key
Press to start playing tape
Pause key
Press to stop tape operation
temporarily. Press again to resume
play.
Playback
• Select “tape” function (10).
• Put in the cassette tape.
• Press play key to active playback
• Adjust the volume control (14/24) to the desire level.
• Use pause key when you want to stop playback temporarily.
• Press stop/eject key when nished.
Remark:
It is possible to play both cassette players one after the other. If you press
the button “pause” and “play” at deck 1 and button “play” at deck 2, than the
tape of deck 1 will be start to play automatically after the tape of deck 2 is
nished.
To Next Page
Loading...
