38
Preparing the Remote Control
• First push to inside as the direction indicated by the arrow (See 1) and then Remove the battery holder
as the direction indicated by the arrow (See 2).
• Replace the battery Set a new battery property with (+)side up as illustrated (See 3).
• Insert the battery holder. Push in the holder to the original position (See 4).
Using the Remote Control
Face the remote control towards the player front face IR mark (remote control signal receiver). Operation
angle: About 30 degree in each the direction of the front of the IR mark.
Note :
The lithium cell in the battery compartment of remote control has been secured for transport with a foil.
Before initial use please remove this foil so that the remote control is ready for operation.
General functions and settings
POWER ON/OFF: Touch the “OFF” ICON on screen to turn the unit o. Press the “On/O/Mod” on the front
panel to turn It on, press it again to turn o.
LOADING/EJECTING A DISC
• Press the POWER button on the front panel to turn the device on.
• Insert the disc with printed side facing up into the disc slot (1).
• The player starts playback the disc automatically.
• Press the eject button on the front panel to eject the disc.
To Next Page
Loading...
Need help?
General
