auna iAdapt - Page 23

23
Dimmer Active / Save energy
Anzeige colored/monochrome
Power Mgmt
Congure to go to standby mode automatically during in the menu or/and without
Wi signal. Choose the power management timer (5/15/30mins) to set the durati-
on of the radio to switch standby mode automatically when you are not controlling
it. Choose Turn o to ignore the power management function.
Sleep Timer
Turn o or set the sleep time of 15/30/60/90/120/150/180 minutes. Once the time
is set, there will be a bed icon with remaining minutes at the top right corner and
the device will turn to standby then. Press Sleep on the remote control for the
shortcut of this function.
Buer Congure the buer time of the music playback, 2/4/8 seconds.
Weather
Activate/deactivate the weather forecast for the standby display. Choose your pre-
ferred temperature unit (°F or °C) and then proceed entering your location. When
activated, the weather forecast is shown in turns with the clock display on the
standby screen (each 10 secs).
Local Radio Setup
There is a shortcut Local Radio under Internet Radio so that you can easily go to
the station list of your location. You may Manual Setup your location, or let the sys-
tem Auto Detect your current location. The system detects the location according
to the IP address of your connected network. Press Local Station to enter this local
radio list directly.
Playback Setup
Select the playback mode of media center – O (no repeat or shule), Repeat all,
Repeat one, or Shule.
DLNA Setup
Default device name for DLNA is AirMusic. You may rename it for DLNA setup on
the PC or mobile.
Equalizer
Default equalizer is Flat, you may change to Normal, Flat, Jazz, Rock, Movie, Clas-
sical, Pop, or News. Press EQ on the remote control to swap among the EQ mode
for shortcut.
Resume When
PWR ON
The system is default to resume internet radio playback if you were listening to
internet radio or media center before switch o the unit. If turn this setting o, the
system will remain in the main menu when switching on the unit.
Software Update
Update software. If there is an updated software version on the server, the system
will notify you when you return to the main menu.
Reset
Restore the default settings. After the CONNCET100 is reset, the system will move
to language setting menu. And it will automatically turn to network setting menu
once the OSD language is elected.