26
E) Encoding bitrate (by remote handset)
You can select the desired bitrate during encoding, the higher bit rate will generate better sound quality and
occupy more space of memory. The selectable range is from 32 / 64 /96 /128 / 192 / 256 kbps respectively
• Set in “ Phono “ function (6) & remain stop mode.
• Press the “Info“ function and the LCD display (2) will show the default bitrate (128 kbps)
• Press skip buttons (13,24) to select the desire bitrate for encoding.
• Press again the “Info“ to conrm the setting and the LCD display (2) will resume to “Phono“ mode
F) Track separation (by remote handset)
You can divide the recording music from phono or tape to USB/SD track by trace during encoding. Every
time when press the (track separation) button once at remote handset during encoding from phono or tape
to USB/SD, the system will generate a new track and continuous the recording. The text “ PHONO “ or “
TAPE “ at LCD display will ashing one time, it mean the unit is creating a new track successfully.
Deleting Files (USB/SD, via Remote Control)
A) Delete single le
• Select at “USB“ or “SD“ mode.
• Press and hold the “Info“ button for 3 seconds and the LCD display (2) will show (del ---001)
• Press Skip forward or Skip backward button to select the le going to delete
• Press the “REC“ button to enter “yes / no“ mode and then press skip forward or skip backward to
select “yes“ or “no“.
• Press the “REC“ button again to conrm the setting.
B) Delete all les
• Select at “USB“ or “SD“ mode.
• Press and hold the “Info“ button for 3 seconds and the LCD display (2) will show (del ---001)
• Press and hold the “Info“ button again and the LCD will show “format / y/n“ and ashing. Then press
Skip forward or Skip backward to select “y (yes)“ or “n (no)“.
• Press the “REC“ button again to conrm the setting.
Remarks: All les inside the USB storage media or SD card will be deleted completely after conrming
to “y (yes)“ mode. Press “Stop“ button once at remote handset to quite delete mode
Removing USB drive / memory card
To remove the USB / memory card, turn o the power or switch the function mode to either cd, tape or tuner
rst. For USB port – un-plug it by pulling out the USB socket directly, for memory card – just pull out the SD
card directly without bending.
To Next Page
Loading...
Need help?
General
