12
STEP 3
Looking through one of the holes in the platter, locate the
small Brass Pulley (the pulley is attached to the turntable
motor).
Then proceed to hook the pulled out part
of the rubber belt by hand around the
Pulley and then line up the centre of the
platter with the silver turntable spindle.
Lower the platter gently onto the deck
and let go until it is back in position.
STEP 4
When the turntable platter is in the correct position, check
the belt is still around the pulley and then replace the ‘C’-
clip to secure the turntable to the spindle.
To Next Page
Loading...
Need help?
General
