auna Verticalo SE DAB - Phono Mode

20
EN
Switch on the device
• Turn on the unit: press the POWER button (on the back of the unit) to
position ”I”, and then press the STANDBY button at the front panel.
“Power On” will be shown on the screen.
• Turn o the unit: press the POWER button (on the back of the unit) to
position ”O”.
NOTE: To help save power consumption, if there is no audio signal input
for about 20 minutes while the unit is powered on, the unit will power o
automatically. To turn power back on and resume playing, you will need to
turn o the power rst, after 5 seconds turn it back on to continue.
PHONO MODE
1. Turn on the unit.
2. Press the MODE button to select the PHONO mode. “PHONO”will be
shown on the screen.
3. Rotate the SPEED CONTROL KNOB (on the back of the unit) to the
correct speed (33
1
⁄3, 45 or 78 rpm) for the track you have selected.
4. Remove the stylus protector from the stylus assembly.
5. Relase the tone arm lock. Use the Cue lever to lift up the tone arm.
6. Move the tone arm over the record where play is desired to begin. Use
the Cue Lever back to the down position. The tone arm will descend
slowly onto the record and begin to play.
7. Rotate the volume control knob to get desired sound level.
8. At the end of the record, the tone arm will stop automatically.
NOTE: Do not turn or stop the turntable manually. Moving or jarring the
turntable without securing the tone arm clamp could result in damage to
the tone arm.