While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Cause Search Solution
Undesirable noises (bed
squeaks and creaks)
Caused by moving parts
touching each other.
Apply Teflon spray.
Do not use oil.
Undesirable noises (bed
squeaks and creaks)
The box spring is not
leveled because the
floor is not absolutely
flat.
Make sure the floor is
absolutely leveled.
Undesirable noises (bed
squeaks and creaks)
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose
when the bed was
moved.
Tighten parts.
Undesirable noises (bed
squeaks and creaks)
The bed is not
positioned away from
the wall.
Position the bed away
from the wall.
Undesirable noises (bed
squeaks and creaks)
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
Remove those objects.
Sparks fly when the
box spring control
system is being
plugged into the
transformer
The plug is already in
the wall socket before
the box spring control
system is connected.
First connect the box
spring control system,
then put the plug into
the socket.
Motor runs for a while
then stops
Faulty Hall sensor in
motor.
Set bed in horizontal
mode by alternately
adjusting up and down a
little at a time. Replace
motor.
GB22
5. Malfunctions
_04DU3_3903 - BW.pdf - pag.22 January 23, 2009
LET OP !!! Lage resolutie!
To Next Page
Loading...
