Front speakers
B3 Rigth channel + (grey)
B4 Right channel – (grey-black)
B5 Left channel + (white)
B6 Left channel – (white-black)
Rear speakers
B1 Right channel + (purple)
B2 Right channel – (purple-black)
B7 Left channel + (green)
B8 Left channel – (green-black)
WARNING
DO NOT OPEN
5
RED
ACC +12V
YELLOW
constant
power
+12V
BLACK
ground
MINUS
BLUE
control
wire
+12V
SWC - steering wheel control input
ANT - radio antenna input (not included)
MIC - external microphone input (not included)
1. Make sure your vehicle's onboard voltage is +12 volts.
2. Remove the fuse from the device before connecting the wires.
3. Connect the yellow (A4) wire to the +12 volt DC power supply.
4. Connect the red wire (A7) to the ACC terminal of the ignition switch.
5. Connect the black wire (A8) to the metal part of the car body.
6. Blue wire (A5) - connect to the amplifier's remote turn-on input or antenna motor control
input.
7. Connect the remaining wires according to the diagram.
Note:
To avoid increased current consumption and unstable operation of the receiver, when
connecting the red wire (A7) to +12 volts (together with the yellow A4), set the “CAR ACC”
function in the “SYSTEM” menu to “NO”!
Power connection
2 WAY mode (regular)
SUB - RCA subwoofer
FL - RCA front (left)
FR - RCA front (right)
RL - RCA rear (left)
RR - RCA rear (right)
3 WAY mode (network)
SUB - RCA subwoofer
FL - RCA MF speaker (left)
FR - RCA MF speaker (right)
RL - RCA tweeter (left)
RR - RCA tweeter (right)
Connecting speaker and RCA cables
ANT
MIC SWC
SUB FL RL
SUB FR RR
15 A
fuse
To Next Page
Loading...
