AURATON RT - Wireless Pairing and Unpairing; Pairing Controller with Receiver; Unpairing Controller from Receiver

6
Pairing of the wireless AURATON R25 RT
controller with the AURATON RT receiver
Aer the receiver is connected to the network, the receiver must be switched on by
quickly pressing the power buon ( ). If the device is switched on, the green power
supply diode becomes illuminated and a single sound signal is emied. In order to switch
o the receiver, e.g. outside of the heang season, press the power buon and hold it
for 3 seconds unl a double sound signal is audible and the green power supply diode is
switched o and, consequently, the heang device is switched o.
In the event of a pairing error, steps 1 and 2 must be repeated. If more errors occur, all
devices must be unpaired by RESETTING the AURATON RT receiver (see „RESET - Unpairing
all devices paired with the AURATON RT receiver”) and then an aempt must be made to
pair the devices again.
NOTE: Only 1 temperature controller may be paired with one receiver.
NOTE: If the wireless controller AURATON R25 RT is sold together with the
AURATON RT receiver, the two devices are factory-paired. Devices purchased separately
must be paired.
1. Pairing of the AURATON R25 RT controller with the AURATON RT receiver is iniated by
pressing the right pairing buon (green triangle ) - a single sound signal is emied
- on the AURATON RT receiver and by holding it pressed for at least 3 s unl the LED
diode starts blinking with green light (double sound signal) - then the buon must be
released.
The AURATON RT receiver waits for pairing for 120 seconds. Aer this period, it
automacally returns to normal operaon.
2. On the AURATON R25 RT, the buon must be pressed for 5 seconds unl the
transmission symbol ( ) is illuminated on the display. Release the buon - the
controller emits the pairing signal for 5 seconds.
3. Successful end of pairing is indicated by the LED diode on the AURATON RT receiver
no longer blinking green, emission of a single sound signal, and the receiver switching
to normal operaon.
1. Unpairing of the AURATON R25 RT controller from the AURATON RT receiver is iniated
by pressing the le unpairing buon (red triangle - ) on the receiver and holding it
for at least 3 seconds unl the LED diode starts blinking red - then the buon must be
released. The sound signal works in the same way as during pairing, i.e. when a buon
is pressed, a short sound is emied and another short sound signal aer 3 seconds.
Unpairing of the controller and the RT receiver