The Aurender W20 has 2 AES/EBU XLR outputs to support dual-wire mode. May also
be used in single wire mode.
6. Optical Output
Connects to an optical input of the digital-to-analog converter.
7. Coaxial RCA Output (SPDIF)
Connects to a digital coaxial input.
8. Coaxial BNC (SPDIF) Output
Connect to the BNC input of the digital-to-analog converter.
9. Coaxial BNC Word Clock Input
Connect to the BNC output of the master word clock.
10. Gigabit Ethernet Port
To connect to a network and Network Attached Storage (NAS) devices. The
Aurender is able to stream music from NAS. The ethernet cable to the network
router should be connected before turning on the Aurender.
11, 12. USB 2.0 Data Ports
Both ports can be used to copy les from USB memory devices. Either port can also
be connected to dCS systems by using the optional USB to RS232 dongle.
Connecting the dCS RS232 control cable will enable automatic clock selection
between the Aurender W20 and the dCS Master Clock. These ports should not be
used as audio outputs.
Warning
Before connecting audio cables, rst check to see that all devices are grounded
using grounded plugs and grounded sockets. In addition, all devices should be
turned o, before connecting any audio or digital cables. If the devices are not
grounded, a voltage potential dierence between devices can cause a voltage surge
through the audio cable that can weaken and eventually damage sensitive circuits in
D/A converters and other devices.
To Next Page
Loading...
