Auriol Z31055A - Calling up the Alarm Times; Switching the Alarm on; off

18 GB/IE
Note: If an alarm time has been set before,
then that previously set alarm time appears in
the LC display. If not, then the display shows
0:00 or AM 12:00.
2. The hour display flashes. Press the SET /
RESET button
20
to set the desired value.
3. Press the ALARM button to confirm your
settings. The minute display flashes.
4. Press the SET / RESET button to set the desired
value.
5. Press the ALARM button to confirm your
settings.
6. Repeat steps 2 to 5 to set the time for Alarm 2.
Calling up the alarm times
Press ALARM button
21
once or twice to
call up the set time for Alarm 1 or Alarm 2
respectively.
Press the ALARM button again to return to the
default display.
Switching the alarm on / off
Press the SET / RESET button
20
once to acti-
vate Alarm 1. Press the SET / RESET button
twice to activate Alarm 2. Press the SET /
RESET button three times to activate Alarm1
and Alarm 2.
Note: The symbol
or appears in the
LC display.
The alarm signal sounds as soon as the set
alarm time is reached. The alarm signal ceases
automatically after a period of 2minutes.