C300H / C300HI / C300H x4 / C300HI x4
C350H / C350HI / C350H x4 / C350HI x4
94
Engine oil (fig. 1)
Use oil for 4-stroke engines in accordance with MIL-L-2104C / API CD or superior.
Always check the API quality on the oil container label to ensure that it is the required
quality.
Your machine leaves the factory with SAE 15W40 viscosity. However, depending on
the environment temperatures, refer to the following chart (fig. 1) to select the proper
viscosity.
If oils of different brand names are used, ensure that you completely empty the crankcase
before adding the new oil.
AUSA recommends oil REPSOL AUSA EFFICIENT for Diesel engines p/n 461.00099.01
Hydraulic Oil
- VG 32 for environment temperatures usually below 50ºF (10ºC)
- VG 46 for environment temperatures between 50F to 120ºF (10ºC to 40ºC)
- VG 68 for environment temperatures above 120ºF (40ºC)
AUSA recommends oil REPSOL AUSA EFFICIENT hydraulics p/n 461.00099.06
Coolant
Always use ethyiene-glycol antifreeze containing corrosion inhibitors especially for
internal combustion aluminium engines. The cooling systems must be filled with
distilled water and antifreeze solution (70 water, 30 antifreeze in a standard machine for
temperatures ranging from -17 °C to 127 °C) (50 water, 50 antifreeze for temperatures
ranging from -35 °C to 145 “C).
Oil for FullGrip
®
System and front axle
Oil AUSA COMPEN EFFICIENT p/n 461.00099.09 with the following characteristics:
- Friction coefficient modifying additives
- “Extreme pressure” and anti-wear capacity
- Good antirust and anticorrosion characteristics
- Excellent thermal stability
- Avoids vibrations and noises
Brake and inching fluid
Only use only SAE 10W or ATF oil in accordance with CAT TO-4 / TO-2 or
ALLISON C-4 / C-3.
AUSA recommends oil REPSOL AUSA EFFICIENT TRANSMISSIONS p/n 461.00099.07
CAUTION:
To avoid serious damage to the brake system or clutch system do not use fluids other
than the recommended one, or mix different fluids for topping up.
Battery electrolyte
This vehicle is equipped with a battery that requires maintenance.
Add distilled water if necessary.
Recommended
fluids and lubricants
(fig. 1)
To Next Page
