Flok 2.0 deutsch
14
Properties for exclusive operation with the preferred fuels
7
Thermal efficiency (fuel efficiency) (based on the NCV)
Thermal efficiency (fuel
efficiency) at nominal heat
efficiency
Minimum heat
output (standard
value)
thermal efficiency (fuel
efficiency) at minimum
heat output (standard
value)
Auxiliary power consumption
Type of heat output/room temperature control
At nominal heat
efficiency
single-level heat output, no room temperature
control
two or more manually adjustable levels, no room
temperature control
Room temperature control with mechanical
thermostat
Pilot flame power requirement
with electronic room temperature control
Pilot flame power
requirement
(if present)
with electronic room temperature control and
daytime regulation
with electronic room temperature control and
weekday regulation
Other regulation options
(Multiple answers possible)
Room temperature control with presence
detection
Room temperature control with open window
detection
with remote control option
1
There is no entry for fireplaces without water-carrying components.
2
Values for annual use efficiency and emissions must be given here for the preferred fuel.
3
Values for annual use efficiency and emissions must be given here for all other suitable fuels.
4
Corresponds to partial load heat output as per EN 16510
5
Specification in mg/m³ for heated filter method (in compliance with Annexe III, number 4, letter a, section i,
point 1) or g/kg for measurement in dilution tunnel (in compliance with Annexe III, number 4, letter a, section
i, point 2 and 3.)
6
Specification mg/m³ for heated filter method (in compliance with Annexe III, number 4, letter a, section i,
point 1) or g/kg for measurement in dilution tunnel (in compliance with Annexe III, number 4, letter a, section
i, point 2 and 3.)
7
Specifications must be made here for the preferred fuel only