Austroflamm Flok 2.0 - Heating In-Between Seasons; Chimney Fire; The most Important Spares-Overview; Keramott

english Flok 2.0
17
Heating in-between seasons
If you heat the stove in between seasons, when the outside
temperatures are higher, the flue gases may not be able
to escape completely and this may lead to disturbances in
the chimney draught, especially if the temperatures are
rising suddenly. The stove has to be charged with less
wood then and the primary air has to be increased so that
the wood can burn down faster (with visible flames) and
thus the chimney draught can stabilize.
Chimney fire
A chimney fire may occur, due to sooting and deposits in
the chimney, if improper or humid fuel is used. In case of a
chimney fire close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an expert
inspect your chimney for cracks and air-tightness after the
burning out of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Keramott
Description
Nr.drawing
Part number
Bottom left, Keramott
1
714930
Bottom right, Keramott
2
714931
Wood retainer, Keramott
3
714932
Rear, Keramott
4
714933
Side component left, Keramott
5
714934
Side component right, Keramott
6
714935
Baffle plate, Keramott
7
714936
Grate
8
716408
Gaskets
Description
Nr.drawing
Part number
Flat gasket 8x2 mm (1,7 m)
13
710096
Gasket round Ø= 8 mm (0,5 m)
14
710696
Gasket round Ø= 14 mm (1,8 m)
15
714223
Other parts
Description
Nr.drawing
Part number
Flok 2.0 door
9
720005
Door handle
10
720016
Flok BA1 door spring
11
714990-15
Flok door glass
12
714920
Glass cleaner ½ litre
--
640070
Stove lacquer
--
650002
Accessories
You can obtain floor plates of glass or steel, care products or the Heat Memory System for heat storage from your certified
dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your stove functions
properly and safely.
The fireplace must not be altered. Any alteration to the stove or improper use will lead to a loss of the warranty title!
Maintenance
To clean the glass, please use a specialised product such as Thermohit glass cleaner. Lacquered surfaces are to be cleaned
only with a cloth (may be damp). Special cleaning agents should also be used for stainless steel surfaces.
Only gaskets in good order ensure the proper function of your stove!
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if necessary more often,
e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by the chimneysweeper. Your
chimneysweeper will inform you of the necessary inspection intervals. An expert should inspect the stove annually.
Keramott numbering = installation instructions!