AUTEC HACRP8 - Plates on HACRP8 unit in a Multi Units or Multi Receiver radio remote control; Warnings for installation; Mounting and fastening the receiving unit in the best position

AUTEC - Air series
Warnings for installation 5
LIRPDE00-03
4.3 Plates on HACRP8 unit in a Multi Units or Multi Receiver radio remote
control
Plate Position Content
radio remote control
identi󰄈cation plate
On the cover of each
receiving unit.
Radio remote control serial number
(MULTI S/N), bar code and
manufacturing year.
receiving unit
identi󰄈cation plate
On the cover of each
receiving unit.
The serial number of the receiving unit
(S/N) and a bar code.
technical data plate
On the cover of each
receiving unit.
MODEL, TYPE and main receiving unit
technical data, marking and possible
radio remote control marks.
5 Warnings for installation
5.1 Mounting and fastening the receiving unit in the best position
The following warnings complete and/or replace the corresponding information in the
paragraph about part A.
The HACRP8 receiving unit, if equipped with a plug, may be directly connected
to the electrical panel of the machine by fastening it through the locking
levers on the plug. It is recommended that adequate protection (e.g. a metal
wire between the receiving unit and the machine) is arranged to prevent it
from falling should a release occur.
A
B
D
F
E
C
A Electrical panel of the machine
B Metal housing of the plug
C Signals on the receiving unit
D Machine maintenance
E Locking levers
F HACRP8 receiving unit