14
4) Use UP/DOWN button to enter new pad thickness, and press Y
button to confirm.
l If you want to quit the setting, press N button and a
“Command Cancelled!” message comes up.
5) An “Adaptation Done!” message comes up on device screen
indicating the setting is performed successfully.
l If the setting is not carried out successfully, an “Adaptation
Failed!” message shows. Repeat operations above to try
again.
6) Wait a few seconds or press any key to return.
E. Adaptation
The Adaptation is used to enter the new calipers thickness of rear
brake calipers after changing brake discs & pads on Audi A8
cars.
1) To set new pad thickness, use UP/DOWN button to select
Adaptation from Select Function menu and press Y button.
2) Wait a few seconds until following screen shows:
........ Select Function ...... ...
5/5
►5) Adaptation
........ Adaptation ...... ...
03 mm
[ ] or [ ] = Change
[N] = Exit, [Y] = Confirm
To Next Page
Loading...