13
Note: Audi A5/A6 and VW Passat do not support adaptation function,
so if you use the device to work on these vehicles, following screen
shows after the activation is completed:
l If the tool fails to open the brake pads, an “Activation
Failed! Please try again!” message comes up.
- Verify that the ignition is ON;
- Check if the brake tool
’s OBD II connector is securely
connected to the vehicle’s DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back to on 10s later;
- Repeat the process.
l If the “Activation Failed!” message does not go away,
then contact your local distributor or the manufacturer’s
customer service department for assistance.
l If the vehicle does not support adaptation, a “The selected
function is not supported!” message shows on the display.
3) If you wish to go to set the thickness of caliper, press Y button to
continue.
l If you do not wish to do the adaptation of caliper at this
moment, press N button or use UP/DOWN button to select
NO and then press Y to exit.
…………… Activate Brake …… .. .
Activation Done!
Press any key to con.
…………… Activate Brake …….. .
Activation Done!
Go to Adaptation?
YES NO
To Next Page
Loading...