12
- Check if the brake tool
’s OBD II connector is securely
connected to the vehicle’s DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back to on 10s later;
- Repeat the process.
l If the “Deactivation Failed!” message does not go away,
then contact your local distributor or the manufacturer’s
customer service department for assistance.
3) Press any key or wait a few seconds to return to previous menu.
D. Activate Brake
WARNING: The EPB system must be activated after finishing the
maintenance/service work on the brakes.
Make sure the vehicle is properly blocked after deactivation of the
system.
1) To close the brake pads after finishing the maintenance/service
work on the brakes, use UP/DOWN button to select Activate
Brake from Select Function menu and press Y button.
2) Wait a few minutes while the device is activating the brakes.
When they are activated successfully, following screen shows:
…………… Activate Brake …….. .
Activation Done!
Go to Adaptation?
YES NO
........ Select Function ...... ...
4/5
1) Read Codes
2) Erase Codes
3) Deactivate Brake
►4) Activate Brake
To Next Page
Loading...