16
u If the brake tool fails to communicate with the vehicle’s
ECU (Engine Control Unit), a “LINK ERROR!” message
shows up on the display.
ü Verify that the ignition is ON;
ü Check if the brake tool
’s OBD II connector is securely
connected to the vehicle’s DLC;
ü Turn the ignition off and turn it back on 10s later.
u If the “LINK ERROR!” message does not go away, then
there might be problems for the brake tool to communicate
with the vehicle. Contact your local distributor or the
manufacturer’s customer service department for assistance.
3) To exit the SBC test, press N button from Select Function menu,
and a prompt comes up asking your confirmation.
4) Press Y button to confirm if you do wish to exit; if you do not
wish to return, press N button or use UP/DOWN button to select
NO and then press Y button to continue.
A. Reading Codes
1) Use UP/DOWN button to select Read Codes from Select
Function menu and press Y button to confirm.
..... Select Function
1/7
► 1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
............ .Exit Test........... ...
Exit SBC Test!
Are you sure?
YES NO
To Next Page
Loading...