17
2) View DTCs and their definitions on screen. If the code definition
covers more than one screen, use Y button to turn to next page(s)
to view additional information.
l The sequence of the DTCs, total number of codes detected
and type of codes (stored or current) will be observed on the
display.
3) When more than one DTC is found, use UP/DOWN button, as
necessary, until all the codes have been shown up.
l If no codes are detected, a “No codes are stored in the
module!” message displays on the screen.
l If the code definition is not found in the built in DTC library,
a “DTC definitions not found! Please refer to vehicle
service manual!” message comes up prompting you to look
up the definition in the vehicle service manual.
4) Press N button to return to previous menu.
B. Erasing Codes
CAUTION: Do not erase the codes before the system has been
checked completely by a technician.
This function is performed with key on engine off (KOEO). Do not
start the engine.
..... Select Function .. ...
1/7
► 1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
C2117 stored
2/3
Control unit A7/3n1
(SBC control unit),
Internal fault
To Next Page
Loading...