Autel EST201 - Page 24

23
19) Follow onscreen instructions to finish the seventh phase.
- Close bleeder screw at rear left brake caliper.
- Open bleeder screw at front left brake caliper.
- Operate brake pedal at least 5 times and release again (pump).
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tight.
20) Press Y button to continue.
21) Wait a few seconds until following screen shows:
l The number “x” on the upper left corner of screen indicates
how many times you need to operate the brake pedal.
22) Operate the brake pedal at least 5 times as instructed.
23) Follow onscreen instructions to finish the eighth phase.
- Hold bleeder hose tight.
24) Press Y button to continue.
25) Follow onscreen instructions to finish the ninth phase.
- Close bleeder screw at front left brake caliper.
- Open bleeder screw at front right brake caliper.
- Operate brake pedal at least 5 times and release again (pump).
- Stop pumping once the brake fluid flows out free of bubbles.
- Hold bleeder hose tight.
26) Press Y button to continue.
27) Wait a few seconds until following screen shows:
28) Operate the brake pedal at least 5 times as instructed.
....5.. Change Fluid .... .
Operate the brake pedal
at least 5 times
and release again
(pump).
....5.. Change Fluid .... .
Operate the brake pedal
at least 5 times
and release again
(pump).