24
29) Follow onscreen instructions to finish the tenth phase.
- Hold bleeder hose tight.
30) Press Y button to continue.
31) Follow onscreen instructions to finish the eleventh phase.
- Close bleeder screw at front right brake caliper.
- All bleeder screws are closed.
- Brake system venting has been completed.
- Set filling and bleeding unit pressureless.
- Leave filling and bleeding unit connected.
32) Press Y button to continue and wait until the “Operation Done!”
message shows:
l If the operation is not carried out successfully, an
“Operation Failed!” message shows. Repeat the process to
try again.
33) Press any key or wait a few seconds to return.
F. Inspect Brake Air
If brake system fails, only the front wheels are braked via a
separate hydraulic circuit without brake servo assistance. The
Inspect Brake Air is to ensure that no air is present in the
separate hydraulic circuit.
Important: DO NOT operate the pedal until you are prompted to
do; otherwise the service may not be completed.
1) Use UP/DOWN button to select Inspect Brake Air from Select
Function menu and press Y button to confirm.
........ Change Fluid .... .
Operation Done!
Press any key to con.
To Next Page
Loading...