3
2 Description of Meters
In the Autel Energy Management System, an energy meter needs to be installed when
running Boost/ALM mode. We recommend you use the following meters in the Autel
Energy Management System:
⚫ SDM230-Modbus V1
⚫ SDM230-Modbus V2
⚫ SDM630-Modbus V2
⚫ SDM630MCT V2
This manual instructs you on how to set the above energy meters (namely setting the
Modbus address, the baud rate, the parity bit, and the stop bit) after they are installed
and connected to an Autel Charger. Please read it carefully.
To Next Page
