IMPORTANT: Before operating or maintaining this unit, please read these instructions careful y, paying extra attention to the safety warnings
and precautions Failure to use this product properly may cause damage and/or personal injury and will void the product warranty
• Insert the Vehicle Data Connector on the MaxiVCI V200 into the
vehicle's DLC, which is general y ocated under the vehicle
dashboard
• Pair the tablet with the MaxiVCI V200 via Bluetooth to establish a
communication link
NOTE: The tablet and the MaxiVCI V200 are configured to auto
matically synchronize with each other on first use, so there shou d
be no need to pair up
• When the MaxiVCI V200 is properly connected to the vehicle and
the tablet, the VCI status button on the bottom bar of the screen
will display a green badge with a check mark at the corner indicat-
ing the tablet is ready to start vehicle diagnosis.
• Ensure the tablet is sufficiently charged or is connected to the
supplied DC power supply.
• Power up the tablet
OR
Alternatively, connect the tablet and the MaxiVCI V200 using the
USB cable
To Previous Page
Loading...
