12 MONTH LIMITED WARRANTY
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in
duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. If you are sending product back for Warranty adjustment, you must include a copy (or original) of your sales receipt
from the place of purchase.
FOR SERVICE CONTACT: AUTO METER PRODUCTS Inc. 413 W. Elm St., Sycamore, IL 60178 USA (866)248-6357 or
Email us at service@autometer.com
2650-600x-10 Rev. B 2/19/13
Wiring
WARNING
Warranty will be void if connected to coil on
MSD ignitions. Attach only to tach terminal.
CAUTION!!!
As a safety precaution, the +12V terminal of
this product should be fused before connecting
it to the 12V ignition switch. We recommend
using a 3 Amp, automotive type fuse.
RED
BLACK
FUSE
(See caution
below)
12V IGNITION
SWITCH (+)
GOOD
ENGINE
GROUND
OR
ELECTRONIC
IGNITION
RED
12 Volt
Battery
+
+
+
–
–
–
BLACK
GREEN
GROUND
GROUND
Coil 2
Coil 1
GREEN
Ignition Switch
WARNING
Do not connect red wire to
coil. Only connect to ignition
switch or battery and through
separate switch.
GREEN
GREEN
GREEN
GREEN
GREEN
GREEN
FUSE
(See caution
below)
Leave calibration switches
set to 1 pulse per revolution.
(See page 1)
CAUTION!!!
As a safety precaution, the +12V
terminal of this product should be
fused before connecting it to the
12V ignition switch. We recommend
using a 3 AMP automotive type fuse
Suggestion: Auto Meter does not provide/offer custom mounting brackets with these
tachometers. Refer to your favorite, local cycle dealer or mail order
house for a size, shape, style that suits your specific needs.
Always connect both green wires to the ignition tach terminal, if available. Otherwise connect both green wires to one of the coil negatives on single
coil ignitions. Older models may have only one coil negative.
Ignitions with Two Ignition Coils
© 2013 Auto Meter Products, Inc.
WARNING
Do not connect red wire to
coil. Only connect to ignition
switch or battery and through
separate switch.
To Previous Page
Loading...
