AUTOCAR E-ACTT - Disable the Vehicle; Primary Procedure

AUTOCAR E-ACTT™FIRST RESPONDERS GUIDE
888-218-3611 AWE 00424 Rev. 001
6
DISABLE THE VEHICLE
High Voltage Disconnect Procedure
DANGER
Never cut, breach or touch high voltage components or cables while energized.
NOTICE
NOTICE
The high voltage system discharge procedure is designed to disable the vehicle HV
system, NOT to discharge the HV batteries. The batteries will remain energized after
this procedure is completed.
WARNING
This vehicle does not have an internal combustion engine. Lack of noise does not
mean the vehicle is OFF.
1. If vehicle is on, turn the vehicle ignition key o󰀨. Remove the key and secure away
from the vehicle. If the vehicle is tted with a LV battery cuto󰀨 switch, turn it to the OFF
position and lockout.
2. Remove LV battery cover to get access to the battery terminals/circuit breakers.
• The battery cover is held in place by four wing nuts
• Remove the front two wing nuts completely
• Loosen the back two wing nuts and slide the cover o󰀨 the vehicle
Top View
Loosen Inner
Remove Outer
Figure 6