AUTO
CRIB
Tools Needed for Installation
• Outlet Tester (can be purchased at Radio Shack)
• Open End Wrench
o (2) 9/16: Used to remove the main platter locking bolt during installation.
o (1) 3 /4: Used to install the leveling feet during installation.
o (1) 3/8: Used to tighten the nyloc bolts on the RoboCrib PC.
• Level
• Cordless Drill: Used to uncrate the RoboCrib.
• Socket Driver (7/16): Used to remove the bolts on the panels of the RoboCrib.
• #2 Phillips Screwdriver
• Pin-In-Hex Screwdriver (included): Used to remove the security bolts on the panels of the
RoboCrib.
• Flat Head Screwdriver
3
To Next Page
Loading...
