upper/lower stations that fail to complete the output )
4. Peak comparison function: When the
"judgment source" of the functional parameters in the
sub-menu is set to 1, this function is enabled. When
the “comparison mode” is selected as 0, the
limit output is output with the real-time measured values
displayed in the lower row. When the
"comparison mode" is selected as 1, and when the real-time
measured value exceeds the value set in the
"automatically compare triggering values", delay
the time set in the "comparison delay", and
then perform the judgment output. When the
"comparison mode" is selected as 2, and when the input port
is "started" and the pulse signal is input, delay
the time set in the "comparison delay", and then perform the
judgment output.
To Next Page
Loading...
Need help?
General