with electrical equipment that easily causes interference, so as
not to affect the performance of the controller.If this can not
be avoided, add a power filter in the power supply loop of the
controller to isolate it.
※
The sensor cable should be as short as possible and away
from the power line and control line to avoid possible
interference.
4) Attentions in Use
※
Try to maintain the stability of power supply, to avoid high
voltage, low voltage, waveform distortion and other
undesirable phenomena.
※
Do not disassemble the controller in case of power on or
power off, so as not to endanger your personal safety or cause
damage to the equipment.
5) Attentions in Maintenance
※
Do not plug in or pull out the connector on the rear panel
of the controller or replace the sensor while the power is on.
※
Non-company or non-professional personnel shouldn't
adjust or set up the controller to avoid misalignment or
imbalance.
To Next Page
Loading...
Need help?
General