SWC Button Re-Assignment Procedure
PLEASE NOTE: This section only applies to button
re-assignment within a conguration. If you are using
the CP2 in manual programming mode (all vehicle
dipswitches up) please refer to the “Manually Mapping
the Steering Wheel Buttons” section.
If you wish to re-assign the Steering wheel control
functions or utilise short press long press dual com-
mand functionality you will need to follow the steps
outlined in this section.
Please read each of the following steps to familiarise
yourself with the process before beginning. The inter-
face must be programmed in the specic order shown
in the chart below.
1. Turn the key to the ignition position. The LED will
illuminate red.
2. Press and hold the programming button on the
side of the interface until the LED illuminates green
Release the programming button.
3. Within 7 seconds, press the button that is to be
learned on the steering wheel. At this point you
have two options:
a. For short press functionality:
Hold the button on the steering wheel until the LED
changes from green to red.
Release the button.
b. For long press functionality:
Continue to hold the button until the LED ashes
be-tween red and amber once. Release the button.
4. If you need to program more buttons, repeat step
3 for each additional audio function on the steering
wheel.
5. If you come across a function in the chart that
your steering wheel does not have, or you do not want
to program, press and release the program button on
the side of the interface to skip that function. The LED
To Next Page
Loading...