statistical evaluation on your PC is optionally available.
For further information concerning ”Data Processing“ please
refer to the software.
Possible Display Information
1. Fe = Measurement on steel or iron substrates
2. NFe = Measurement on non-ferrous metallic substrates
3. ERR = Incorrect handling
4. INFI = Incorrect substrate, e.g. measuring beyond the
measuring range or measuring on wood
5. BAT = Battery is getting weak, please exchange.
Information: the measured values will remain
stored.
6. bloc = Displayed alternating with the block number
7. End = Memory or block capacity out of space
8. N = a) alternating with Fe or NFe
= number of measurements
b) alternating with Ae
= number of measurements of the active block
9. Ae = Average value measured in the active block
10. = Maximum value measured in the active block
11. = Minimum value measured in the active block
Accessories
The electronic coating thickness gauge QNix® 1500 is
delivered with a carrying case containing Fe and NFe zero
plates, a 9 V alkaline battery, two probe protection rings and
Instruction Manual.
To Next Page
Loading...
