What to do if my Automation Dr. Nix QNix 5500 Measuring Instruments device doesn’t switch on?
If your Automation Dr. Nix Measuring Instruments device doesn’t switch on, the batteries may be drained. Replace the batteries or connect the device to a USB connection.
Why does calibration with reference plates produce implausible results on Automation Dr. Nix Measuring Instruments?
Implausible results during calibration of Automation Dr. Nix Measuring Instruments with reference plates can occur if the incorrect reference plate is selected. Make sure to select the Fe/NFe reference plate based on your probe. If the issue persists, the device or probe may be defective.
What does it mean if the sensor ring briefly lights up blue during probe change on Automation Dr. Nix QNix 5500 Measuring Instruments (no error)?
If the sensor ring briefly lights up blue during a probe change on your Automation Dr. Nix Measuring Instruments and there's no error, it indicates that the probe is connected correctly.
General| Type | Coating Thickness Gauge |
|---|---|
| Probe Type | Integrated |
| Ferrous Substrates (Fe) | Yes |
| Non-Ferrous Substrates (NFe) | Yes |
| Display | LCD |
| Power Supply | 2 x AA batteries |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Measuring Principle | Magnetic Induction / Eddy Current |
| Measurement Range | 0 - 2000 µm |
| Resolution | 1 μm |
To Next Page
