11
4.6. Delete User‘s Adjustment
Pressing and holding the button until the countdown for switch-o starts will delete the last measure-
ment results. If you repeat this three times within 5 seconds, the user‘s adjustment will be deleted also –
the gauge goes back to factory status. When exceeding 5 seconds the counted repeats are set back to 0.
In case of a user‘s adjustment, the according symbol is shown in the status bar.
After deleting the user‘s adjustment the symbol disappears; factory adjustment is now active.
5. Troubleshooting
If the device is not responding as expected, please check the following items:
Error Possible cause Action
Device does not switch on Batteries drained Replace the batteries
Calibration with reference plates
produces implausible results.
Incorrect reference plate selected
Device or probe defective
Select the reference plate
Fe/NFe based on your probe
Please contact your authorised
service location.
Sensor ring lights up blue Measuring range exceeded
Sensor ring briefly lights up blue
during probe change
no error Probe is connected correctly
To Next Page
Loading...
Need help?
General
