Automationdirect.com DL06 - Page 195

DL06 Micro PLC User Manual, 3rd Edition, Rev. E
5-34
Chapter 5: Standard RLL Instructions
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
In the following example, when X1 is on, output point Y2 on the output module will turn
on. For instruction entry on the Handheld Programmer, you can use the instruction number
(#350) as shown, or type each letter of the command.
In the following example, when X1 or X4 is on, Y2 will energize.
Y aaa
OUTI
OROUTI
Y aaa
1
B
ENT
X1
Y2
OUTI
DirectSOFT32
Handheld Programmer Keystrokes
STR
$
INST#
O
5
F
3
D
0
A
ENT ENT
2
C
ENT
STR
$
X1
X4
Y2
OR OUTI
Y2
OR OUTI
DirectSOFT32
Handheld Programmer Keystrokes
STR
$
1
B
ENT
ENT
4
E
INST#
O
5
F
3
D
0
A
ENT ENT
2
C
ENT
INST#
O
5
F
3
D
0
A
ENT ENT
2
C
ENT
Operand Data Type DL06 Range
aaa
Outputs Y 0–777
DS Used
HPP Used
DS Used
HPP Used
DirectSOFT
DirectSOFT
Out Immediate (OUTI)
The Out Immediate instruction reflects the status of the rung (on/off)
and outputs the discrete (on/off) status to the specified module output
point and the image register at the time the instruction is executed. If
multiple Out Immediate instructions referencing the same discrete
point are used, it is possible for the module output status to change
multiple times in a CPU scan. See Or Out Immediate.
Or Out Immediate (OROUTI)
The Or Out Immediate instruction has been designed to use more than
1 rung of discrete logic to control a single output. Multiple Or Out
Immediate instructions referencing the same output coil may be used,
since all contacts controlling the output are ored together. If the status
of any rung is on at the time the instruction is executed, the output will
also be on.