Autool BT360 - Operation; Pre-Test Procedures; Connect Tester Procedure; Key Description and Controls

5
PRODUCT STRUCTURE
Structural Diagram
A
Red and black
testing clamps
B
Display screen
C
Direction buttons
D
Confirm button
E
Return button
B
C
D
E
A
OPERATION STEPS
●
●
Attach the red (positive) and black (negative) testing clamps
to the battery.
If connected correctly, the display shows the startup screen.
Press “Confirm” to proceed (Note: Testing is not possible if
the battery voltage is below 8V).
Connect to the Battery
Standard
Review data Set Up
Quick Test