Autopage RF-320 - Feature Programming

8
FEATURE PROGRAMMING:
FEATURE “A” PROGRAMMING:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3rd push) until one chirp with a long
chirp is heard, then release the valet switch. You are now in the Alarm feature ‘A’
programming mode.
3. Press and release the transmitter button corresponding to the feature you want to
program. (See chart on next page)
The siren chirps and LED pause will indicate new setting.
The factory default settings are always [1] LED flash, [1] siren chirp.
4. Press the transmitter button to change the feature. Simply continue pressing the
transmitter button again until the module advances to your desired setting.
a. In this case, Press the button again, the module will advance
to [2] LED flash, [2] horn chirp.
b. Press the button again; the module will advance to [3] LED flash, [3] horn chirps etc.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three
pulses
Four Chirps /
LED four
pulses
1
Active arming
Passiv
e arming
without passive
door locking
Passive arming
with passive
door locking.
2
Automatic Rearm
off
Automatic Rearm
on
3
Instant Door Ajar
error chirp
45 seconds delay
Door Ajar error
chirp.
4
Siren Confirmation
chirp on only
All Confirmation
chirps On
Horn
Confirmation
chirp on only
All
Confirmation
chirps off
5 +
H3/2 White wire=
Dome Light
Output
H3/2 White wire=
3
rd
Channel
Momentary
H3/2 White =
3
rd
channel
Latched
6 +
Lock/
Arm &
Unlock/Disarm
Confirmation
Chirps
Lock/Arm
Confirmation
Chirp Only
Exit: Turn Ignition to ‘ON’ position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.