TRANSMITTER OPERATION:
Button = Silent Arm/Disarm (DEFAULT)
Silent Arm/Disarm
+
3rd Channel Auxiliary Push Buttons Together
Button = 3
rd
Channel Auxiliary (See Feature Programming “I”-4)
3rd Channel Auxiliary
+
Silent Arm/Disarm Push Buttons Together
ACTIVE ARMING – LOCK & ARM:
1. Press
button on transmitter.
2. The siren will chirp once and parking light will flash once indicating that the system is now
armed. The vehicle doors will lock upon arming when interfaced with the security system.
Note: Defective sensor reminder: If the siren sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. (See Feature “I - 3 Programming)
SILENT ARM ING / DISARMING: Press the
button on the transmitter to arm or disarm
your security system with no chirp sound heard; arm / disarm confirmation will be through the
vehicles parking lights only. (factory default)
Press the
+
buttons together for silent arm/disarm if you have the
button
programmed to the 3
rd
channel operation. (See feature-programming I-4)
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS: Press the
button on the transmitter
twice within 3 seconds will arm the security system, by-pass the shock sensor or the optional
sensor connected to 4 pin plug. The system will chirp one additional time to confirm the
sensor bypass mode was activated. The sensor bypass feature is programmed to activate for
one arming cycle only. The security system will return to normal operation during the next
arming cycle.
Transmitter Button System Function Remark
Arm / Lock door
–
Arm and Delete Optional Sensor Press twice within 3 sec
Car Locator System in Armed.
Panic function Press 3 seconds
Disarm & Unlock Door
–
2 Steps Door Unlock / Disarm
System
Press twice within 3 seconds.
2
nd
Channel Trunk Release Press 2 seconds
-
Passive Arming By-pass Press twice during
passive arming 30 sec. timer
Side button
2
nd Car Operation Garage
Door Opener
Side Button Switching Code
To Next Page
Loading...
