35
Annex 5: Periodic maintenance table
Service object, description of activities and
maintenance technique
Required
materials,
tools
Electrical equipment
Check the security of the attachment
of the heater electrical contacts. In case of
dirt or oil deposit on the contacts, remove
with suede moistened in petrol. In case of
carbon deposit on the operating interface of
contacts, smooth it out with fine glass
paper № 150 and wipe with petrol.
Air intake
Dismantle the air intake, rinse with
petrol and clean out the net by blowing
with compressed air
Glow plug (for FLOW 14D)
- Dismantle the air intake, remove
rubber cap protecting the glow plug,
disconnect the leads, unscrew the ignition
plug and remove carbon deposit from it.
- Check the glow plug rubber cap for
mechanical damage. If this is the case,
replace the glow plug.
S=17
wrench,
clean rags,
benzene
(acetone),
screwdriver
Combustion chamber
Clean up the 1.5 mm hole for air supply
to the ignition plug
Fuel pump
Prevention of formation of viscous film
deposits on driving parts of the fuel pump.
Fluid system
Clean up the heat exchanger
screwdriver,
brush, tank
for cooling
liquid
Fuel system
Check the fuel pipe for leakage; tighten up
clamp connections, if necessary.
To Next Page
Loading...
