AUTOTERM FLOW-5D - Annex 6: Maintenance Check List

36
Annex 6: Maintenance check list
DATE:
VEHICLE YEAR:
HEATER MODEL:
VEHICLE MAKE:
SERIAL NO.:
VEHICLE MODEL:
TECHNICAN NAME
SURNAME
VIN:
CATEGORY
DIAGNOSTIC TASK
✓

Preliminary Check
Installation Position
Fuel pump mounting position (where applicable)
Proper length of fuel line before and after fuel pump
Heater is well protected from road spray and dirt
Fuel Level
Battery Condition and Voltage
Visual Inspection
Wiring connections clean, tight and corrosion free
Intake and Exhaust position
Fuel line routing and Clamps tight
Debris in combustion or heated air intake
Fuses
Coolant flow direction
Maintenance
Run heater 20 minutes minimum once a flame is established
Clean air intake of debris
Clean and tighten battery terminal connections
Check and clean glow plug
Check and clean exhaust pipe