• The relevant safety precautions must be observed when working with
coolant liquids and electrical and fuel systems when installing and
dismantling the heater.
• Do not disconnect power from the heater before the purge cycle
ends.
• When the heater has been switched off, do not switch it on again for
5-10 seconds.
• Due to poisonous exhaust gases and the risk of suffocation, DO
NOT use the heater in closed and/or unventilated places (e.g.
garage, workshop, etc.)
• Do not step on the heater or put any objects on it and in it.
• Electric wiring, the air intake, and the fuel pipe must be protected
from contact with sharp edges of vehicle structures.
• If any work was done on a cooling system (repair or replacement of
coolant), it is necessary to bleed the system.
• For safety reasons, contact the service shop to troubleshoot the heater
if it fails to launch twice in a row.
• In case of faults in the operation of the heater, contact only specialized
repair organizations authorized by AUTOTERM.
To Next Page
Loading...
Need help?
General
