Autotrol 255/760 - Valve Installation

PAGE 7Help: 888-426-5001 QualityWaterForLess.com
3) Before filling the tank, place a piece of painter's
tape over the top of the riser to prevent resin
from dropping down inside the riser tube as
shown in Figure 7-A. i Avoid using duct tape
which leaves behind unwanted residue
4) Place the included filling funnel over the top of
the tank as shown in Figure 7-B and prepare to
fill the tank. If your softener system came with
gravel , please pour this into the tank first , then
pour in the included resin media afterwards
FIGuRe 7-a FIGuRe 7-B
stan daRd
FIne mesH
3 ›InstallInG tHe autotRol 255/760 ValVe
1) Remove the filling funnel and tape and while
using the included silicone lubricant packet, lubri-
cate the inner and outer o-rings on the bottom of
the Autotrol 255/760 Valve as shown in Figures
7-C and 7-D
2) Next, install the top screen (standard OR fine
mesh)
to the bottom of the Autotrol 255/760 Valve
as seen in Figure 7-E (you may need to strip the
groove tabs with a razor before attaching). Then
place the valve onto the top of the tank, being sure
that the riser tube fits into the central o-ring on the
valve, as shown in Figure 7-F. Hand-tighten the
valve to the tank. Do not use Teflon tape or pipe
dope on the valve or tank threading
FIGuRe 7-C FIGuRe 7-e
FIGuRe 7-d
FIGuRe 7-F